Industry News

  • Home  >
  • News  >
  • Industry News  >
  • Hydraulic Press: How to Improve the Parallel Accuracy
  • Hydraulic Press: How to Improve the Parallel Accuracy

    Date:2024-09-26 

    In the process of assembling the hydraulic press, in order to adjust the accuracy of the hydraulic press, it is necessary to adjust the parallelism of the slide table and the platform with a beam adjustment nut, and then tighten as many lock nuts as possible (under no load condition) to make fine adjustments. In fine tuning, the plane of the movable beam and the vertical piston rod, the deviation of the plane parallel to the plane of deviation of this movable beam below the work table, can reflect the vertical center line of the piston on the work table. As a result, the activity of the beam can be kept in the middle position, and the parallelism error is measured first.
    Hydraulic Press: How to Improve the Parallel Accuracy

    Front adjustment four bundles of miniature lock nuts are unscrewed. Use the dial gauge to check the parallelism of the plane below the movable beam with the plane before and after the table (approximately). If this is not the case, the two adjusting nuts (left) or the two adjusting nuts (right) should be tightened or loosened before pressurization, and then measured and adjusted again until the requirements are met.
    (approximately) before and after the parallelism requirement, then use the above method to adjust the parallelism (front and back). When it is found that the parallelism error of the two positions is contrary to the measurement data compared to the request, the inspection situation and inspection should be considered. Check the accuracy of the moving beam assembly to meet the requirements. After checking and adjusting the hydraulic press in parallel, it should be checked whether the verticality of the walking beam meets the requirements. When the requirements are not met. Adjust the method and parallelism in the same way until you meet the requirements.
    Similarly, if the perpendicularity of the accuracy is found to conflict with the parallelism, the sum value is greater than the specified value, check the quality and check the quality of the moving beam assembly parts list.
    If you need high precision hydraulic press solution, please contact us.
    top